
STGRID (CCP4: Supported Program)NAMEstgrid  Generate stereographic net plot for use with polarrfnSYNOPSISstgrid plot file.ploDESCRIPTIONThe PLOT84 plot file on logical name PLOT is a stereographic net intended to be printed on a transparency for overlaying on the stereographic projection plots produced by polarrfn. The stereographic net produced by STGRID is used to measure the angular coordinates on a stereographic projection. (To measure the angle between a pair of points, see STNET.) Each point on the projection corresponds to a point in polar angle space, which represents an orientation of a rotated Patterson function.The angle must be measured along any one of the great circles (projected lines of longitude connecting opposite poles  note that the sphere is projected so that the poles are at the left and righthand edges and the equator runs vertically!). The other set of lines (projected lines of latitude parallel to the equator) subdivide the great circles and are calibrated in degrees to allow the angle to be read off. Note that the net used must have exactly the same diameter as the plot, otherwise the results will not be accurate. The plot file may be converted to PostScript or HPGL for printing (resetting line width) with pltdev: pltdev i file.plo lnw .2Print the PostScript file plot84.ps on your laser printer and photocopy the stereographic net onto a transparent sheet. BUGSThe diameter shown in the title (currently 17.1cm) assumes you are using size A4 paper. If not, the diameter should still come out the same as your plots from Polarrfn. Just edit the title in the call to PLTCTX and recompile. However if you want to make a net with a specific diameter, you'll have to unravel the mysteries of PLOT84 yourself  it probably involves fiddling with the window parameters (see DATA statement for array W in the source).SEE ALSOstnet, pltdev, plot84, polarrfn, rfcorrAUTHORIan Tickle 